Your ultimate customizing knowledge guide

Do you have any questions? We have the answers.

Yes, the MILLER Exhaust exhaust systems comply with all regulations in the EC countries and Switzerland, so that you can enjoy the MILLER sound without any worries (+5 dB(A) from the stationary noise level noted in the vehicle registration document; see U.1)

On average, you can expect an increase in motorcycle performance of +2-3PS and +3-4NM more with our exhaust systems – without modifying the motorcycle.
With the installation of our racing silencers, even more is possible, as the exhaust gas flow rate is higher.
Modification of the ECU is not necessary with our exhaust systems.

Ordering requires specialist knowledge, as does installation, which must be carried out by qualified personnel.

The products are EC/BE-EC approved for the CH standard.
In addition to homologation, Swiss customers require a valid approval certificate from a Swiss importer.
Deliveries for Switzerland are made via our Swiss general importer Gooddrive AG.

Yes, catalytic converters are used in the exhaust systems in accordance with the environmental guidelines of the specific Euro standard.

Miller Exhaust® products comply with EC/BE-EC homologations and are approved for EC countries and Switzerland.
Additional registration in the vehicle documents is not required.
The guidelines cover all Euro standards.

The db absorber is an interchangeable component that limits noise emissions to legal limits.

The abbreviations stand for various standards and approvals relating to noise, emission control and product conformity.
EPA means that the product complies with noise regulations according to US federal regulations.
ECE refers to compliance with the requirements of the UN regulation ECE-R92 for motorcycle and car exhaust systems.
EC indicates conformity with the requirements of the EU Directive or Regulation.
ABE indicates that the product complies with German type approval requirements.
SA indicates that the product meets the US Forest Service standard for spark arresters.

No, the use of the silencer without the dB absorber or with the Racing dB absorber is not permitted on public roads.

The brands and trademarks are subject to the applicable provisions of trademark law and the ownership rights of the registered owners.

Verification is carried out in accordance with TÜV International Certification procedures for auditing, certification and verification and is monitored regularly.

The products are manufactured and produced in Germany – exclusively from stainless steel and aluminum – to ensure consistent and exceptional quality.

You are responsible for the shipping costs of your motorcycle parts to us.

Please remove the coarse dirt, we will do the rest for you: We clean and degrease all motorcycle parts before further processing.

No, this cannot happen: We use our form to clarify feasibility in advance.
If we give you the green light, your customizing wish can be fulfilled!

As a rule, you will receive a binding offer 3 – 5 working days after we receive your motorcycle parts.

In principle, we can sandblast all metal parts.
Please always specify the dimensions of the metal part you would like us to sandblast.

No, after sandblasting, only further processing with wet paint is possible.